Check the Frost Line by Zip Code Before Digging Footings
Building decks, fences, and anything above grade requires the use of footings for support. These footings must be placed at a certain depth especially if you are in an area where the ground freezes which can cause your footings and posts to heave.
This depth is determined by the frost line in your area and the map below will show you how deep you need to dig to safely place your footings.
Table Of Contents
- What is a Frost Line
- What is Frost Heave?
- When to Build
- Frost Line Map
- Frost Line by Zip Code
- Tips for Digging
What is a Frost Line
The frost line is the depth at which the ground freezes. It’s important to know the frost line depth for construction purposes. Water pipes should always be set below a frost line to prevent them from freezing in the winter.
It’s also important that the footings for a building or a deck are placed well below the frost line so the posts don’t shift as the ground freezes and thaws. Check your local building codes to determine the proper depth past a frost line a footing should sit.
What is Frost Heave?
Frost heave is when the ground freezes and then thaws. This process causes the ground and anything in it to move upwards. You can see how this can be detrimental to any posts or footings.
This is why it’s so important to be aware of the frost line and dig below it when installing your footings.
When to Build
If you are in a cold zone and aren’t in a rush to build, it’s best to wait until spring to start digging. The ground will be thawed by then making it easier to dig to the proper depth.
Mark a stick at the proper depth and keep it within easy reach of your construction project so you can take regular measurements.
Frost Line Map
This frost line map provides a general idea of where the frost line is in your area. If you live on the edge of the line, it’s best to go with the recommendations of the colder side to avoid any issues.
This map is from the National Snow and Ice Data center and shows the frost line map across the United States. Note how it moves down from 72-inch depth to a 6-inch depth.
The maximum frost line depth is 100-inches as seen near the tip of Minnesota, North Dakota, and Alaska, all the way to zero inches in Florida, southern Arizona, and southern California.
Frost Line by Zip Code
If the map isn’t accurate enough for you. Check your frost line by zip code or address using this map from the National Weather Service.
As we mentioned before, make sure you check with your local building codes before you start digging.
Tips for Digging
Anytime you are digging, it’s best to know the frost line as you will know how deep the water pipes are so you can avoid them.
Here in Los Angeles where the ground doesn’t freeze, the irrigation and sprinkler pipes are not buried very deep, so you need to be extra careful when digging around them.
A shovel and post hole digger are all that is needed to dig a deep hole, but if you’ve got large rocks or hard pack in your area then a long pry bar is also helpful.
An auger is the fastest way to dig holes and can save you a lot of time and money even with the cost of renting. A handheld auger is usually the best option as they are cheaper to rent and easier to work with and maneuver. For a long fence line an auger at the end of a bobcat or PTO tractor is a great investment as it will dig the holes fast and accurately.
Posted on September 27, 2023
Timothy is the founder and editor of Charles & Hudson and former editor at Popular Mechanics, This Old House, and Lifehacker. His work has been published on Wired, Bob Vila, DIY Network, and The Family Handyman. He is also the founder of the Webby-nominated Built by Kids and host of the popular Tool Crave podcast.